If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Here is a picture of the two pullers. Both pullers are used the same way. You screw both tight on to the prop the smack the end with a hammer. Some people think with the "c" puller is that you tighten the heck out of it then the prop falls off, wrong. That will just bend the prop puller, all the "c" does is put tension on the prop until you smack the end of the puller with your hammer not the free hammer in the harmonic kit.
Look at the difference in beefiness! This Acme is a sexy one......that and my old prop needed replacing for sure....for comparison it was 13x13, new one is 13x15 I think?
BTW the puller is a nice kit, although my prop slipped right off with no help required.
Comment