Tower Wiring

[flackpack]

I ran 12 AWG. It was tougher to pull, but I felt it would have less impedence. I am running only two 6.5" speakers, but I ran enough wire to add 2 more in the future.

[burr]

Been searching to find a thread with this info and finally found this.

I have the same tower as extremeh2o and am about to install tower speakers kicker kmt6. I am chasing pictures of how people have run their speaker wires for this tower.

So guys post them up and I would also like to see photos of stereo installs into boats similar to mine (I have a 2003 20v Aussie built)

Bit of a hijack I know but the thread is four years old

[Waterski-Rebel]

I have the 2004 metcraft tower, and there is a hole on the bottom of the tower mount that goes through the deck, and into the boat behind the seat. You may want to try and remove the seat if possible, and see if you have the same hole. Mine was pre-drilled.

[burr]

Is that on the left side of the boat waterski-rebel.

I can see the predrilled hole in the top part of the tower on both sides. Haven't yet looked for a hole in the bottom plate of the tower leg yet. I cannot see a hole in the bottom tower leg to feed the wire back into after coming out of the predrilled hole in the top part of the tower ie around the hinge.

Does anyone's tower have a predrilled hole going into the bottom tower leg.

[Waterski-Rebel]

I used the one on the drivers side, I assume there is a hole on both sides, but don't know for sure.

[lee]

There is a hole in the tower base plate, just unbolt the tower drill hole in the boat run the wire thru the deck and the short part of the tower then attach the tower back to the boat.