If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Mine will be moving down to central Illinois in about a month. When did you pick up the new boat? It looks good.
Thanks.
I bought it at Reeds Marine Lake Delevan Wisconsin. So far, I have been happy with them as a dealer. The boat is still up there getting a few things installed. I won't pick her up until mid to late April. I am a warm water boater.
Hello - This is my first post. Here is a picture of my family's new 2006 20v. We bought late last fall but we haven't had it out yet (except for the demo run). I cant wait for the lake to thaw so we can start enjoying it!
Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More
No unfortunately all I have is that shot right now. Why r u interested in diffferent angles?
Yea, you!
I was planning on comparing it to a Standard Dorsey or EZ loader To see if it was noticeable and actually humch much you lowed it. Post some side angle pictures when you get you boat back.
I was planning on comparing it to a Standard Dorsey or EZ loader To see if it was noticeable and actually humch much you lowed it. Post some side angle pictures when you get you boat back.
Not me
If you look at the shot I have you can see the hull is inset below the fender line by about 3 inches. This will make it a pain to load but there was no other solution to the problem we had to overcome.
This inset will cause us to load very slowly because there is only a tad over 3 inches total clearance between the fenders and z boat.
Comment