I have a 2000 Tige 21V with the old Metcraft tower. I am going to replace the tower with a Monster MT2 tower. I want to attach the supports in the same locations (I know Ill need to drill new holes) but I would like to do this so that my boat cover will still fit since it is a very tight fit around the tower legs.
I was trying to figure out how I would get access to the aft leg backing plates, but I cannot figure out how to get access to them so that I could install a new plate with the new tower.
I cant find any how to videos on removing those interior side panels either. Does anyone know how to remove those panels to get access to those backing plates?
I was trying to figure out how I would get access to the aft leg backing plates, but I cannot figure out how to get access to them so that I could install a new plate with the new tower.
I cant find any how to videos on removing those interior side panels either. Does anyone know how to remove those panels to get access to those backing plates?
Comment