Announcement

Collapse
No announcement yet.

2015 Z1 GSA tabs

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    2015 Z1 GSA tabs

    I am in the process of replacing the Taps3 tabs with GSA tabs. I seemed to be having trouble with the stroke on the actuators. As I cycle the actuators through the dealer link on the display they seem to not return as far as they extend. Which after a few cycles they are barely above level in the up position. I am wondering everyones thought on this. The actuators seem to sound ok, they don't seem to be making any abnormal sounds as the are working. I assume if they fail they completely quit functioning. As I hold tension on the ram by hand as they are cycled they seem to vary in stroke by about 1/4" per cycle.

    Is it possible the actuators are the problem, or is the Tige Touch giving uneven length of signal?
    Tags: gsa
    #2
    This is the video I took over several cycles.

    https://youtu.be/Ev28KCF6Sw8

    Comment

      #3
      Video is private. My guess is you need new actuators, they don’t always stop working completely and if they’re acting up under no load once you put it under load you will have no hope.
      That is assuming everything hinges freely and they aren’t binding.

      Comment

        #4
        Dealer should be able to replace em
        surf till u die.

        Comment

          #5
          Whats the battery voltage here?
          Germaine Marine
          "A proud dealer of Tige, Supra, Moomba and ATX performance boats"

          Comment

            #6
            Old version of software. You need 10182017 that has overrun when going home and has higher amperage. Message me and I will send you a link.
            Oh Yeah!

            Comment

              #7
              Voltage on the display shows 12 volts.

              Comment

                #8
                Koolaid, message sent. Please let me know if you don't receive it. I don't have the best of luck with the private message on this forum.

                Comment

                  #9
                  Thanks KoolAid, the updated program seemed to bring it around.

                  Comment

                    #10
                    Excellent! Get it out on the water and play :-)
                    Oh Yeah!

                    Comment

                      #11
                      Will i need that update with a 2017 z3?


                      Sent from my iPhone using Tapatalk

                      Comment

                        #12
                        Hopefully Koolaid will comment, I understand the update to be dated 10-18-2017. So that is a good question if your boat falls before or after the firmware date.

                        Comment

                          #13
                          2015-2016 7" screens are one set of software so the 10182017 is the final version of that generation.

                          2017-2019 7" screens a different generation and take a different format of software. Its final version is 20190321
                          Oh Yeah!

                          Comment

                            #14
                            Thank you!


                            Sent from my iPhone using Tapatalk

                            Comment

                            Previous template Next
                            Working...
                            X