Does anyone have a diagram that shows what each fuse is for? I’m having a problem to get the TAPS 3 working and want to check the fuses first. Thanks.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
-
-
Theres no fuses for TAPS 3. Driven by PDM (Power Distribution Module). PDM diagnostic screen while show faults(opens, shorts, etc) What is your TAPS3 not doing?? -
When I switch from left to right nothing happens. I’ve had the boat for 2 years so I know pretty well what it should be doing.Originally posted by freeheel4life View Post
I also had it prepped for the summer by our local boat guy but I think he didn’t tighten the battery terminals properly and we had some ground faults. They seem to have gone away after tightening the terminals.
Sent from my iPhone using TapatalkComment
-
Not sure the history you have had but it took 3 sets of Rams maybe 4 on my 2016 R20 to get mine to consistently operate properly. That’s even after getting it working fine over a summer put it up for winter then start of next season it wouldn’t work. They finally swapped everything out to the 2018 setup so far so good.
Sent from my iPhone using TapatalkComment
-
It seems like I’m chasing something else. TAPs work but now I have a Heater open/ Ground Short
Any ideas what that’s about?
Sent from my iPhone using TapatalkComment
-
That's an o2 sensor code. Would have to be at the shop to tell you which one. There are 4 in total. Believe that one is post catComment
-
Thanks so much. Appreciate the troubleshooting
Sent from my iPhone using TapatalkComment
Comment