Fiberglass seperation on port bow

[cdomby]

I got my Z3 re-skinned and have been out a few times since getting back from the upholstery ship. Yesterday, I was sitting on the port side bow seat, looked to my left and saw that the area where the cup holder is has completely separated from the rest of the boat. I imagine something happened when they were trying to get the arm rest/ side trim out or pushing on it trying to get the big front cushion in/ out. Needless to say, I'm pissed.

Does anyone know how this can be repaired?

If water gets in there, is there anywhere for it to go? Same scenario if a front ballast bag had a leak.

Thanks in advanceIMG_4804.jpg

[chpthril]

Im not sure I follow what that edge could have separated from? It looks to me, to be the cutout for the cup holder/speaker insert and during reassembly of the interior, the bottom edge of the insert ended up inside of the cutout rather then over it.

[cdomby]

I thought that the cup holder/speaker insert was molded to the white fiberglass and broke off. So, sounds like the cupholder/speaker insert is a separate piece and should go over the white edge. Makes sense. I'll have to check it out when I can get to the boat...
Thanks as always!