AVX Error

[Jesture]

Finally got my 2015 Tige Z1 on the water here in MN...lake was frozen 2 weeks ago. Had the boat since new and always maintained by the dealer, and started my surf session driving a buddy (so I could enjoy driving my boat again) and the AVX is throwing an error symbol.

Has anyone seen this before? Does anyone know additional troubleshooting? The remote still works and was able to move the AVX...but that stopped after a couple times. Any help is appreciated!

AVX Error.jpg

[BJM]

I had this happen to our boat. The dealer put in the demo code to allow the AVX to move while the boat is stationary. He was able to move it all the way down and it reset itself.

I thought no the rams were out of sync with each other. It hasn’t happened again since then. I bet your dealer will give you the code over the phone and walk you through getting it into demo mode.

[BJM]

I had this happen to our boat. The dealer put in the demo code to allow the AVX to move while the boat is stationary. He was able to move it all the way down and it reset itself.

I thought no the rams were out of sync with each other. It hasn’t happened again since then. I bet your dealer will give you the code over the phone and walk you through getting it into demo mode.

[Jesture]

Thanks! I sent an email to the dealer, hopefully this is the issue and they pass over the code.