Boat lift bunk spacing

[jmc01002]

I have a new rzx3 and have a boat lift that previously had a 23' supra on it. I am wondering if anyone knows what they're inside to inside measurements are on the front and rear bungs of the lift. The trailer has 3 sets so I am not sure what to go with. Any help is greatly appreciated. Just don't want to add any strain to the hull nor do I want it to sit crooked on the lift. Thanks!

[freeheel4life]

I have a new rzx3 and have a boat lift that previously had a 23' supra on it. I am wondering if anyone knows what they're inside to inside measurements are on the front and rear bungs of the lift. The trailer has 3 sets so I am not sure what to go with. Any help is greatly appreciated. Just don't want to add any strain to the hull nor do I want it to sit crooked on the lift. Thanks!

If you look at the very front set of bunks on boatmate holding an RZX3 they barely touch the keel an then taper away from the hull and don't even touch. Seems like they are more designed to "catch" the boat and line it up. The middle set and rears actually carry the boat. I don't have any measurements on them, but I wouldn't even look at the front set.

[BLucas86]

I tapered mine in towards the bow, to avoid resting on a chine. If currently on the trailer, its pretty easy to crawl under and measure. Id start with the rear and then figure out what to do with that massive keel. I almost had clearance issues, but was able to adjust accordingly..