Taps 3 not working

[Bakes5]

My 2016 Z3 had bad tower speaker static when I got it. I adjusted the gain via the amp gain and the static went away. Kinda weird that the tower speakers just quit working. I doubt it’s anything to do with the touchpad as everything is externally controlled via head unit and WS420. Stereo works just fine without the touchpad even being on. I’d look for a lose wire or fuse in regards to your tower speakers.

[outkastmunkey]

So I went the whole summer trouble free by starting the engine before turning on the screen. They did the most up to date firmware when I took it in for winterizing and they said it should have fixed the problem. They also replaced the rams again at that time the replacement ones they put on were on the recall list. I am taking it out tomorrow so we shall see! I know the O2 sense took a crap but I will take it next week to get that fixed.


Sent from my iPad using Tapatalk

[smoothtoup]

So I went the whole summer trouble free by starting the engine before turning on the screen. They did the most up to date firmware when I took it in for winterizing and they said it should have fixed the problem. They also replaced the rams again at that time the replacement ones they put on were on the recall list. I am taking it out tomorrow so we shall see! I know the O2 sense took a crap but I will take it next week to get that fixed.


Sent from my iPad using Tapatalk

What year? On the 2018 you have to turn the screen on for the blower to work.

[outkastmunkey]

What year? On the 2018 you have to turn the screen on for the blower to work.

It's a 2016. I would turn the screen on and blower then shutoff right before starting engine.



Sent from my iPad using Tapatalk

[Berrymad]

I just got my 2016 RZX back from shop and all 3 of the actuators were bad and replaced. The dealership told me that Tige has had problems with a specific actuator leaking water into
it causing it to stop working. Tige is now using a different actuator and haven't had any problems yet. Took the boat out twice already and it works beautifully so I'm hoping the problem
is fixed for good.

[bsreid]

It's a 2016. I would turn the screen on and blower then shutoff right before starting engine.



Sent from my iPad using Tapatalk

So why wouldn’t the screen come on without starting it? I’m having a similar problem. Thanks!

[JCP]

Possibly low voltage on the house battery. See if it works with the battery switch on combine.

[bsreid]

Both batteries are high 12v and everything works on combine.

[JCP]

What are voltage reading at each battery with engine off and battery switch off?

[bsreid]

12.8 and 12.6 volts from a volt meter.. having it serviced next week so I’ll get them to check it.

http://www.tigeowners.com/forum/show...878#post791878

[chpthril]

Both batteries are high 12v and everything works on combine.

This does point to a low house battery. if the battery(s) is sufficient, then COMBINE would not make a difference.

[bsreid]

Putting the switch on combine alows for use of both batteries right? So it can run off the starter.

[chpthril]

Putting the switch on combine alows for use of both batteries right?

Yes, this is what the COMBINE is for. However, if both batteries are good and charged, the combining offers no advantage. If the screen doesnt power up on ON, but does on COMBINE, it points to a battery low issue.

Not saying it is a low battery, just what it seems to be.

[bsreid]

then why is my volt meter reading 12.8 volts, just a dud battery?

[outkastmunkey]

So why wouldn’t the screen come on without starting it? I’m having a similar problem. Thanks!

So my screen always turned on. They came to the determination that when I turned the screen on and then started the engine
It would geek out the system and my taps 3 wouldn't function. So I went all last summer starting the engine then turning on the screen. They said the latest firmware update they did when they winterized should have fixed the problem. They also switched out the rams again because the ones that they replaced the originals were also on the recall list. But first time out this year the goofy side would not clean up so I stood on the swim step and felt that the rams was not moving on that side so the boat is at the shop getting a new taps 3 system on it. Hopefully I will have it for the rare hot day we are going to have this Sunday.


Sent from my iPad using Tapatalk