Getting ready for Lake Mead

[chpthril]

The gray set is definitely the front right and left. The black is going to likely be rear/sub. Its very common for the black to be selectable between full range for rear speakers or low-pass for a woofer. So IMO, I would make sure the black rear is set to full pass and NOT sub or low pass.

With a single 4 chnl full range amp and mono amp. I would use the gray front RCA to the 4 chnl. A pair of splitters may be needed. Use the 4 chnl to drive the tower pods only. Use the black rear to the mono amp for the woofer. This leaves the two 6x9 and two 6.5 to be driven by the head unit, until a new 4 chnl can be installed. Of course, this is based on there being enough of the leads left to splice into for the speakers. If not, then you will need to wire all eight speakers to the 4 chnl amp.

Wiring for the head unit:
yellow = constant B+ (common post of the main battery switch same as amps)
black = ground with amps
red = switched B+ (either a rocker or key switch)
blue/wht = amp turn-on output
wht = front left speaker + and -
gray = front right + & -
purple = rear right + & -
green = rear left + & -

solid is + and BLK strip is -

[Goodtimes619]

I got most of the trashed wires out of the way today and began getting the wiring harness put back together. Then got sick of sitting in the hole doing wires so I stained the deck.
I also talked to the upholstery shop today and they are supposed to be all done by noon tomorrow, ill have pics up when i get them back.


IMG_20160908_154539484_HDR.jpgIMG_20160908_154546497.jpgIMG_20160908_160607126_HDR.jpgIMG_20160908_160614843_TOP.jpgIMG_20160908_165210432.jpg

[Germaine Marine]

really looks great man!

[Goodtimes619]

While I was waiting for the upholstery to finish up today I had to change the tire on my bike it was a little sketchy but worked out well and now its safe!!!

Then I picked up the upholstery from the shop and this is how it turned out...

IMG_20160909_163959988_HDR.jpgIMG_20160909_164002514.jpgIMG_20160909_164023343.jpgIMG_20160909_190227519_HDR.jpgIMG_20160909_190235633_HDR.jpgIMG_20160909_190243224_HDR.jpgIMG_20160909_190522048.jpg

I am pretty happy with the quality. The blue accent is not smooth it has a grippy but soft texture and I think it looks much better than the tired purple and grey it came with.
Unfortunately the boat is still full of tools and the oil cooler hasn't come in the mail yet so I am not going to install them until all the greasy work is done and I know the boat is running right and cleaned again. So this is how they are being stored for the the next few days.


IMG_20160909_201005443.jpg
Still working slowly on the stereo, Wiring and electrical is my least favorite thing to do but it will get done early next week.

[h2osk8er00]

Looking great! Got your Koozie in today! Ready for the well deserved beverage of choice Kevin!

[Goodtimes619]

Awesome! it might be champagne out of a red solo cup after all this

[h2osk8er00]

Awesome! it might be champagne out of a red solo cup after all this

What day you rolling out? You have a lot more work ahead this week?

[Goodtimes619]

Leaving here Friday morning hopefully be there before noon. I have a lot of work but I am waiting for the last part to come in the mail before I can do it.

[h2osk8er00]

Cool man. Can't wait to see the fruit of your labor brotha.

[Goodtimes619]

Transmission is still slipping when throttling up to 1000 RPM. I am going to put it together and head over to mead in the morning regardless. anyone have a PSI gauge for tranny or engine oil?

this is where were starting at today.....


IMG_20160915_113301724_HDR.jpgIMG_20160915_113315884_HDR.jpg

[Goodtimes619]

we had to modify the speakers to fit in the new upholstery.

IMG_20160915_163126913.jpg

It looks good and can putt slowly for the weekend so it will be a good time.

IMG_20160915_183644729_HDR.jpgIMG_20160915_183658739_HDR.jpgIMG_20160915_183704387_HDR.jpg

[TeamAllen]

Looks great. See you there!