I am looking at a house at the LOZ it has a boat lift with poly boxes under it held a 25 foot boat how hard is it to switch it over to inboard for a Z3?
-
-
It probably depends on the lift and your aptitude. Boat lifts are really just like a big erector set, you just need to measure carefully and aim to center the weight on the tank(s). A tape measure, socket wrench and a box or crescent wrench is all I needed. Probably need a buddy because the bunk assemblies can get heavy.
I have a condo at LOZ. The lift that was there was setup for a 28 i/o. I adjusted the bunks myself for a 23 jetboat I had, and then for my 2015 Z3. Mine was't hard to do at all, but I did need to buy longer legs/stands for the bunks so the prop and rudder would clear the cross members. If you had posted 8 hours earlier I could have taken dimensions for you, lol! The only slight downside for me is that I cannot angle my bunks and the boat has just the tinest bit of downward pitch on the nose. Doesn't hurt anything other than keep me from getting all the water out of my cooler without using a rag for the last little bit.
What is the lift rated for?
Going rate is about $300 to pay someone to come out and do it for you (not counting parts).
Comment