Engine Compartment Divider Pannel

[NHarp1]

Any new 2015 or 2016 Z1 or Z3 owners experiencing problems with the engine compartment divider panel "warping" or "flexing" under the pressure of the ballast bags? I am not sure if Tige has fixed the problem any by installing these "reinforcement ribs" to the panels?
I know Wakemakers.com have a fix out there or DIY aluminum angle material with rounded bolt heads and Teflon nuts.
http://www.wakemakers.com/engine-div...nel-saver.html
Thanks

[trace]

'15 Z1 here with no panel reinforcements and they do bow in a lot, but mine also don't touch anything either...

[JCP]

My 15 Z3 has this problem. I have reinforced the panels and they still pop out at times. It appears that the U-channel that is screwed to the bottom of the boat is not a deep enough groove. The boards popping out have caused one of my bags to tear off of its hanger, so I am about to try for a warranty claim, to get the bag replaced. When the board on my port side pops out, it comes to a stop against the o2 sensor. (not good). Tige claims that they are working on a fix but that has been going on for months. Pretty easy fix: deeper grooved U-channel and support the divider panel boards. How hard is that Tige?