So as per a previous thread, I figured out the first owner of my Z1 removed the flame arrestor and replaced it with wire mesh. I have been told by several members this is unsafe so of course I am looking to rectify the problem. I also realize looking at my set up that the bracket which would allow the engine cover to screw down is also missing. That bracket is part number 6 on this diagram.
Intakediagram.JPG
I've tried to locate this part online with not much luck. I know it is part number R090358A. Any ideas where I can get this?
Then there is the question of a flame arrestor. Is this K&N one worth the money? The stock one has a part number of R145027 which again I have no idea where to buy.
Any help advice would be appreciated.
k&n.JPG
Intakediagram.JPG
I've tried to locate this part online with not much luck. I know it is part number R090358A. Any ideas where I can get this?
Then there is the question of a flame arrestor. Is this K&N one worth the money? The stock one has a part number of R145027 which again I have no idea where to buy.
Any help advice would be appreciated.
k&n.JPG
Comment