New Prop ?

[gibbs114]

Will the 1235 fit on my z1 without any clearance issues?

2014 Z1 has the 537 now.


Sent from my iPhone using Tapatalk

[trace]

Yes, it'll fit, no problem. What you need to check is your trailer clearance. If your trailer was built late enough it will clear. Some of the earlier Z 1 trailers after the hull change didn't have enough clearance. The'15 boats are shipping with 15" props.

[Iwndr]

Yes it fits fine on the boat but like Trace says make sure you check your clearance on the trailer if it's a boatmate.

[gibbs114]

Not enough clearance for the 1235 on my trailer is what I was told by the dealer.


Sent from my iPhone using Tapatalk

[Iwndr]

Not enough clearance for the 1235 on my trailer is what I was told by the dealer.


Sent from my iPhone using Tapatalk

They need to shim it then. Boatmate paid to shim mine twice. 1/2" the first Time and an inch the second time.

[ChrisBarnes05-12-84]

I have a 1235 on my z1. It clears by the width of a piece of paper, but it does clear

[Dandy]

We didn't think there would be room on ours for the 1235. I contacted ACME and they recommended the 1433. It was an improvement over the 537. FYI - we had a 1" shim done to our trailer - two 1/2"blocks stacked at each bunk to trailer location.

[dodgeman]

We put a 1235 on our Z1, trailer is shimed 3/4" and now have lots of clearance. The boat also sits better on the trailer after the shims were installed. I would go with the 1235, why settle. JMHO.

[JohnnieMo]

Dodgeman, did they shim all the bunks (or even the full length?) Boatmate only sent shims for the rear-most arms on mine. It seems to make the difference, but it is sure a half arsed approach.

I also picked up the 1433, but haven't installed it yet because I haven't added ballast yet. Next year.

[dodgeman]

JohnnieMo, every bunk is shimmed from front to back. I think you got screwed. My shims were sent directly to me from Boatmate, if yours were sent to your dealer, I think they are cutting some corners, not COOL!!!! Good luck.