Announcement

Collapse
No announcement yet.

Pleas help z3 no balast ,stero ,taps or 12 volt plugs ?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Pleas help z3 no balast ,stero ,taps or 12 volt plugs ?

    Whent out today ballist filled fine but no stero checked fuses they seem fine then no taps I go to drain ballist and no drain or fill I tried useing the manual switch with no luck any help would be much appreciated!

    #2
    Well I now have all but stero no power to the yellow 15 amp wire at back of stero I do have power to the red 1 amp is ther a fuse before all this I can't seem to find one?

    Comment


      #3
      Possible breaker ?? What boat :??

      Sent from my HTC One_M8 using Tapatalk

      Comment


        #4
        2012 z3

        Comment


          #5
          Hey Luke don't forget to check all your grounds too. Might be something in the Tige touch too. Good luck or you could always drive north and come surf with us.

          Comment


            #6
            Thanks topaz !! I think I'm getting close ill see in the am

            Comment


              #7
              Do u have power at the tige touch ? Do you have the two battery setup ?


              Sent from my HTC One_M8 using Tapatalk

              Comment


                #8
                Yes have power at Tt and both batt are good

                Comment


                  #9
                  Gotta ask the obvious, but by what means are you determining "power"? Is this a voltage reading from a digital volt meter? if so, then replacing a blown amp fuse at the battery would restore battery voltage to the amp, thus to the yellow head-unit B+ wire thats typically piggybacked into one of the amp's B+ lugs. Take that volt meter and test there.
                  Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More

                  Comment


                    #10
                    Found the problem wet sounds amp has a problem it blew the 60a buss fuse and when I was able to get power back to the amp it was making burning electric smell but was working tested amp and it seemed to have bad continuity going to send it in I was able to rig up tower speakers temporarily . Thanks for the help!!!

                    Comment

                    Working...
                    X