Announcement

Collapse
No announcement yet.

Help - 2013 z1 dies. Radio works. Won't start

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #16
    There are circuit breakers all over books and crannies of the boat , there are a few at the back off the ACR ,and a few mounted up and behind the main disconnect etc..

    Sent from my HTC One_M8 using Tapatalk

    Comment


      #17
      I didn't see any by the batteries. I will check there this morning.

      Comment


        #18
        But like chp. Said check the batts as well, even brand new batterys fail , I keep mine on a genius battery charger and even only being one year old , the house batt can no longer hold a full charge ,

        Sent from my HTC One_M8 using Tapatalk

        Comment


          #19
          Can you tell me exactly where the fuse is for the starter? I will also check batteries this am.

          Comment


            #20
            Cranking battery is connected directly to starters main post, no fuse. The solenoid wire is likely protected pre switch.
            Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More

            Comment


              #21
              What should the batteries crank at? Going to put them on a tester in a few minutes.

              Comment


                #22
                A fully charged battery should be 12.5-13.0
                Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More

                Comment


                  #23
                  Does not having a fuse for the bilge matter? That wouldn't cause my issues, right?
                  Attached Files

                  Comment


                    #24
                    So do you have any battery voltage ?? I am also wondering if a wire has discconected as well ??


                    Sent from my HTC One_M8 using Tapatalk

                    Comment


                      #25
                      Originally posted by dmbisbest View Post
                      Does not having a fuse for the bilge matter? That wouldn't cause my issues, right?
                      No because I believe the bilge is on a circuit breaker ,

                      Sent from my HTC One_M8 using Tapatalk

                      Comment


                        #26
                        Batteries tested at 12.33 and 12.58

                        Now have no power to anything, other than the manual switches under the steering column.

                        Comment


                          #27
                          Okay , you need to make sure your switch is on , if no power then , you need to check If a wire or more likely a ground has come off , put a voltage meter on the starter solenoid and see if there is power there

                          Sent from my HTC One_M8 using Tapatalk

                          Comment


                            #28
                            Now testing circuits up front, they seem to be getting power also. This is frustrating as $hit.

                            Comment


                              #29
                              We have checked all the ground wires we could find. They are all good. Since there is power to the upfront circuits, could it be the ignition switch?

                              Comment


                                #30
                                Actually it's kinda fun , you learn a lot about your boat , and it's like a puzzle ,it's how I learned about my boat

                                Sent from my HTC One_M8 using Tapatalk

                                Comment

                                Working...
                                X