2013 R20 Bimini Top from Tige factory - info needed

[gogiants]

Looking to get the Bimini Top for the 2013 R20. The basic top from Tige factory - not the one that holds the boards.
Does anyone have it? Like it? Problems w/ it? Picture Please (as Tige does not have a pic of it anywhere). Cost?
Many Thanks :-)

[boardman74]

They work well and are easy up and down. Draw back is they are expensive. In that $1500 range I believe. It basically works the same way as the Alpha Z bimini. You install 2 clamps that have a post on them for the back. Then the front uses a telescoping leg to adjust. Main bow stays attached all the time and it stows strapped against the tower. We had a demo last fall that had one and it worked well. I almost thought it was easier up and down than my Alpha Z bimini.

[boardman74]

Here is a picture I found online.

[Ewok]

Looks like the same Bimini for an alpha z.

[boardman74]

Its not quite the same, but its pretty close. The rear is very similar but the way the front attaches and works is a little different. The adjustable braces come off and store in a pocket inside the boot. The rear uses a collar with a peg on it and the pole goes over it instead of inside like the Alpha Z. It is close but a completely different top than the RZR uses with the Alpha Z. Just as spendy though!

[gogiants]

Boardman74... thanks so much for the info and the pic... REALLY was helpful and appreciated.

[gogiants]

Ewok... thanks for the input... appreciate it!