If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a few weeks till my 2009 RZ2 comes out of storage ... and I need to know how deep a garage needs to be for the RZ2 to fit (trailer tongue swung in, platform removed).
My RZ2 on a road runner trailer uses 26' from the back of the swim platform to the end of the folded tongue. And if I removed the platform it would save 2'.
2009 RZ2, PCM 343, MLA Surf Ballast, Premium Sound.
2013 Toyota Sequoia 4WD W/Timbren SES
I'm guessing different trailer, and the swim platform comes to a peak at the center which may extend a few inches past your swim platform. And I took the measurement from the back wall which has a 1" gap from the back of the swim platform.
2009 RZ2, PCM 343, MLA Surf Ballast, Premium Sound.
2013 Toyota Sequoia 4WD W/Timbren SES
The nose of my boat is almost in a vertical line with forward point on the folded tongue. The platform on mine is parallel to the back wall of the garage - pointless.
Our 12 RZ2 measures just a tick over 22 feet on a CTW trailer and it does not stick out past the bow when folded. We looked at a 13 RZ2 on a Boat mate trailer and it stuck out around 8 inches past the bow when folded.
Formertigeowners.com
I used to be a member in the past.
Comment