Upgrade Prop 2012 RZR

[NHarp1]

I am getting a VX for my 2012 RZR, PCM 343
I have the upgraded rear 750lb fat sacks & 200 lb in floor ballast
I am curious if any RZR owners have upgraded to the ACME 1273 prop for better getting out of the pocket power?
I will have to measure my boatmate to make sure I have the additional clearance going from 13.5" to a 14.5" prop. That equates to 1/2" additional clearance.
Any concerns?

http://www.wakeprops.com/wakeboard-b...oat-propellers

Thanks

[Z3CO23]

If you don't mind answering, what are you looking at price wise on your VX? WWS here in Denver thinks it would cost me somewhere in the area of $5000 to put the VX on my boat. They said there is a bunch of expense in putting the new brackets on (since my 2011 has the old brackets) then filling and re-gellcoating the old holes, and shipping the VX with the new platform is not cheap. If it's gonna cost that much I don't know that I can justify it and I'm just gonna build a surf flap.

I have read about a lot of people having really good results with the 1235 in the low end power ranges. Losing 3-5 mph on the top end. No personal experience.

[houstonshark]

I tested the 1235 on my RZR for almost 2 months and the only thing it really did for me is waste a ton of fuel. It did not get out of the hole any better than the stock 1631 prop. If I remember, it may have actually taken longer to get on plane.

You'd be much better off putting spacers on the TAPS bracket to allow the plate to go lower in the water.