If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I would say the G23 is just like a Tige. The ARS just continues down the tige path. The ARS hull does look a bit different than the G23 other than the convex V part. Looks like the ARS is a bit deeper. All based on these pics that were just posted. When I get a chance I will take some pics and do a direct comparo. Either way, the G23 and ARS are both awesome looking boats. Only so many ways to get a boat hull to look like a spoon to enhance its water displacement.
2016 Tige Z3, 2014 Tige Z3
2013 Tige Z3, 2004 Tige 24V (Legen....dary)
For years I had to put up with the Nautique dealers telling every custormer at a boat show that the trim plate was a crutch for a bad hull design , now they have a crutch .
Question: Nick you said you had the stock ballast 1500 pounds under the floor I thought stock ballast was 3,000 pounds? or is it going to be 1,500 pounds under the floor and an additional 1,500 pounds above the floor?
Comment