Gents, I have a bit of problem with my tige touch on my 2011 RZR and I wanted to see if anyone else had experienced this...
Everything works as per normal for about 5 to 10 minutes on the water and then I lose some instrumentation. On the dash the speedometer, tach, water temp and gas gauge stops reading (the speedometer and tach will stop at last reported info until you shut the boat off and then return to 0) but the taps gauge still works.
In regards to the tige touch, the respective gauges in the gauge screen will not read, the speed set will not set (as it is not getting info on RPM and Speed I presume) and hour meter does not read. I do however have all stereo control, depth finder, heater, lights etc...
The guys at the dealership have been very helpful but are sort of limited as I am 8 hours away from the nearest tige dealer...they are researching hard on their side so I thought I would pose the question to the group on Tigeowners...
I have updated the viper with a flash from the dealer to no avail...any thoughts? Has anyone experienced this?
Everything works as per normal for about 5 to 10 minutes on the water and then I lose some instrumentation. On the dash the speedometer, tach, water temp and gas gauge stops reading (the speedometer and tach will stop at last reported info until you shut the boat off and then return to 0) but the taps gauge still works.
In regards to the tige touch, the respective gauges in the gauge screen will not read, the speed set will not set (as it is not getting info on RPM and Speed I presume) and hour meter does not read. I do however have all stereo control, depth finder, heater, lights etc...
The guys at the dealership have been very helpful but are sort of limited as I am 8 hours away from the nearest tige dealer...they are researching hard on their side so I thought I would pose the question to the group on Tigeowners...
I have updated the viper with a flash from the dealer to no avail...any thoughts? Has anyone experienced this?
Comment