Announcement

Collapse
No announcement yet.

boat dies after 3000 rpm

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    boat dies after 3000 rpm

    Can't get my 04 24V past 3000 rpm. It starts chugging and drops to idle and then high idles at 2000 rpm. All I did was change the fuel filter.
    2016 Tige Z3, 2014 Tige Z3
    2013 Tige Z3, 2004 Tige 24V (Legen....dary)

    #2
    6.0 liter with gforce fuel pump.
    2016 Tige Z3, 2014 Tige Z3
    2013 Tige Z3, 2004 Tige 24V (Legen....dary)

    Comment


      #3
      Ok now it is doing it when I hammer on gas or around 4300 rpm. So stumped on this one.

      Oil pressure issue? 75 psi at 4300 rpm.
      2016 Tige Z3, 2014 Tige Z3
      2013 Tige Z3, 2004 Tige 24V (Legen....dary)

      Comment


        #4
        Throttle position sensor.
        Fixing everyone elses boat just so I can use mine...

        Comment


          #5
          Is it making a hissing noise like the motor is sucking air?

          Comment


            #6
            I would second the throttle position sensor and if that isn't it then it could be related to the variable valve timing system. I have been having some similar issues with my 6L and I think I have it narrowed down to the little actuator valve that controls the cam position. The part is cheap but the problem is that it is a major job to get to it in order to replace.

            I would start by having it scanned and seeing if it is throwing any codes to point you in the right direction.

            Comment


              #7
              Once again must have been bad gas. Added a couple cans of Seafoam and the problem went away. Boat is running great now.
              2016 Tige Z3, 2014 Tige Z3
              2013 Tige Z3, 2004 Tige 24V (Legen....dary)

              Comment

              Working...
              X