Thanks Tige and WWS

[Wickedcummins]

I just wanted to take some time out of my day and thank Tige and Bill at WWS for taking the time to get my failed rear engine cover replaced! Alot of people wont take the time to thank people as I am different and will.. Thanks to both of them for standing behind a product that deff had some issues..

Here are some pics! On the boat when issue was noticed

[Wickedcummins]

Panel showed up tuesday and I went down and picked it up today and swapped the foam and cover and reinstalled.. Some pics of it torn down shows how bad it was

[Wickedcummins]

And here is a picture of the new panel and then reinstalled on the boat

[skippabcool]

Looks good. Did you just get the board and you did all the work?

[Wickedcummins]

Looks good. Did you just get the board and you did all the work?

Yes just got the board.. Removed the old cover. removed backing panel removed about 150 staples removed vinyl removed foam with razor and pulling.. spray new board with glue reinstalled foam reinstalled new plastic install vinyl fitted and stapled with stainless staples. reinstalled backing after heating with geat gun and straighting. reintalled panel onto boat. removed cover and had wife sew in zip panels over the vents to engine compartment so when its not raining they can be left open. This winter her and I are going to do a new cover in white! THinking about draining coolant to run water wetter instead.. It not only keeps engine temps cooler its had stuff to eliminate heat soak after engines are shut off!

[Wickedcummins]

I am completly happy with just the board as thats the only failed part. I dont want anything more than what failed do to something not being correct... My only concern is that it does it again.. I hope tige see's this and makes whatever change they need to do.. Id hate to have anyone else have to feel the pain of there boat doing this.. Its sad to see your prize possession do this.. More so when your like I am gonna buy a new boat so I can enjoy it with out having major issues with it!

[skippabcool]

It looks to be a different board is it?

[Allan Kendall]

awesome......they are awesome....WWS!

[Wickedcummins]

It looks to be a different board is it?

color yes. And seems a little more rigid but from the side it looks the same.. My fingers are crossed it dont happen again but I cant figure out how it happened in the first place.. errrrr I just hope they spend the time to get to the bottom of it

[WakerideN]

looks like marine board... the first not so much. guess my question is this... you did all the work... and did the compensate you for your time material ext? If not, not so sure I would be all that happy personally. Your workmanship is the bomb that is for sure. I just hope they made it right is all.