Trailer Fix

[skippabcool]

When I bought my boat it had a bend in the piece that holds the bow roller. When I went out Saturday I had left my boat hooked to the trailer, since I didn't check it at home on the fak a lake, so I could make sure all was well. When I went up to unhook the strap from the eye the bow piece was bending like nothing. I had asked in here where a good place to go would be. One TO had mentioned it would be an easy fix. I PM'd them and asked who could do it he said that he could. He was availible today and took it to him and he rebuilt the piece into a much better piece.

I have to give a shout out to WickedCummins for helping me out. He did an awesome job. Thanks.

Here is the bad

[skippabcool]

Here are some pics as it is being fixed as well as the finally results. Better than new.

[Timmy!]

Looks nice!

[skippabcool]

In the last pic you can see what the original should have looked like, in the back ground, and the new one.

[Timmy!]

I have the same trailer and on mine the piece that holds the roller is all bent up from comin in a little too hot in the wind.

[skippabcool]

I still have no idea how the original owner bent it in the first place.

[Timmy!]

I still have no idea how the original owner bent it in the first place.

I can assure you that it wasn't that hard to do. It's a poor design. GJ fixed you up so it can't happen again.

[Iwndr]

Dam nice job by Wicked the man has skillz

[skippabcool]

I can assure you that it wasn't that hard to do. It's a poor design. GJ fixed you up so it can't happen again.

It ain't going no where.

[skippabcool]

We were comparing trailers seeing what they have improved. One thing is that they are now putting a support piece on the piece that the bunks are held on by.

The fenders are outside of the support brackets.

The trailer guide poles are on springs and attached different.

[Wickedcummins]

You bet Glad I could help you out.. Yah its unbreakable lol.. 3x3 .250 wall then a piece of 2 inch .250 dom... Crap *** factory setup someone should be slapped around! Thinking I should build some caps so a person can cut it off slide the new one on and bolt it up and be good to go!

[mls6722]

Looks great Skippa. You must be happy that it was done fast and right.

[Wickedcummins]

yah not the quailty of my old extreme trailer... The boat mates look well built also!!

[Wakeman22]

Looks great. Good job wicked. That's how it should have been made in the first place.

[dingleberry]

Looks like great work by Wicked