Boatmate trailer fender width

[bspot]

Can anyone tell me the trailer fender width on the boatmate trailers with the factory 18" wheel upgrade and the fender width with stock wheel size.

[NICKYPOO]

I'm not trying to be sarcastic but, did you try calling Boatmate?

[bspot]

yah they said they needed a vin to say for sure. Most likely 9" on the upgraded wheels and 7.5" on the stock size. Just trying to confirm the 7.5 on the stock size.

[NICKYPOO]

Ahhh. I see. Just for the hell of it, I went out and measured mine (9") but, I don't think its going to help as my Boatmate trailer is 12 years old. I don't think 18" were even thought of back then.

[bspot]

Ahhh. I see. Just for the hell of it, I went out and measured mine (9") but, I don't think its going to help as my Boatmate trailer is 12 years old. I don't think 18" were even thought of back then.

Yah, probably not. Thanks

[flyguy]

Stock wheels on 2010 Boatmate - 9" fender width

[Iwndr]

I'll measure mine when I get home on Thursday Bspot, I have the 18" wheels

[adamsjstt]

I have a boatmate with stock wheels and my fender width is closer to 10.5".

[bspot]

Thanks guys.

[jmhatchett]

I have a 2009 upgraded trailer with the 18" wheels, i believe the tire runs about 10.5" wide so i would only ASSUME that the fender on my trailer is around 12"

[thtrog]

This is a copy of the message recieved from Boatmate when I was thinking about upgrading to 18" wheels in '09, which I did not do:

In addition to the wheels and tires, you will need the following:
-2 new 3000# 93/76T axle weldments (beam only,does not include trailing arms)…$205 each, plus a $70 fee to add brake line and paint charge.
-2 new 10.75” wide fenders with Malibu logo and non-skid...$185 each (painted)or you can go with stainless steel fenders...$255 each (stainless)
-plus shipping