New 2012 RZR

[NHarp1]

Transom SeaDeck

I decided to cover up some of the transom walk area with some SeaDeck. Cost me $120 but gives me the peace of mind nobody will slip when wet.
Here are some before and after.

[carcrz]

That looks great! I think we'll be doing that before too long.

[Timmy!]

All that was only $120? That seems really cheap to me! Was it precut? Looks great!!

[MooseX]

very nice..looks factory or better

[skippabcool]

All that was only $120? That seems really cheap to me! Was it precut? Looks great!!

I was surprised as well because I was told the minimum order was $150.

It does look great and should make it so it is not slippery.

[NHarp1]

I ordered 3 precut small sheets (18" * 38"). ($40 a sheet)
http://seadek.com/

I made a paper pattern with a pencil rub to transfer the pattern image to paper.
I used 2 1/2 sheets for my boat.
The peel and stick adhesive is killer....sticks quick!
I use a new carpet knife (blade) to cut 1/4 foam.
I would recommend to cut 1/8 inch bigger to play it safe.

[Timmy!]

Wow! You cut those patterns yourself!?!?! Even more impressive! Nice work Nick!

[thtrog]

Very nice upgrade!

[rushin]

Nice addition.

[Iwndr]

Very Nice Nick

[Shamus]

oh that looks like a must have for any enthusiast! Nice work! I think I better order up some seadeck...

[NHarp1]

RZR Wake

Found a few pictures of the wake before we winterized. Should be able to dial it in a bit more for wakeboarding this spring at 18-22 mph. As for surfing, I was far back on the wake and still getting good push at 13 mph. Normally we surf at 10.5.

[Duncan]

I ordered 3 precut small sheets (18" * 38"). ($40 a sheet)
http://seadek.com/

I made a paper pattern with a pencil rub to transfer the pattern image to paper.
I used 2 1/2 sheets for my boat.
The peel and stick adhesive is killer....sticks quick!
I use a new carpet knife (blade) to cut 1/4 foam.
I would recommend to cut 1/8 inch bigger to play it safe.

How does the black seadek material hold temperature? Probably not as hot as the hard black plastic of 2009 and earlier swim platform pads?

[NHarp1]

SEADEK suggests to not use black if you live in AZ or real hot climates. I guess there could be slight shrinkage compared to lighter colors. I do not think it retains alot of heat compared to black gelcoat most of us have touched on other boats!

[NHarp1]

2012 RZR Observation Seat

After reading a few other threads about the RZR observation seat binding in the corner when lifting up, I contacted Tige for a vinyl strap for my boat. I was experiencing the same problem. Harvey from Tige sent me a length of vinyl, I cut it to lenght and secured under the seat with stainless screw and washer. Now the seat trap works perfect to evenly pull up the seat.

Thanks everyone for the suggestion! Not sure if Tige will be installing this strap on all seats to include the Z3.