Is This the Heater Connection Point

[jzts0214]

I just installed a heater on my 11 22ve. On your first pic I hooked on hose to the part you have pointed out. If you look at the right in the pic You will see the big square plug. I removed the plug and installed the second hose there.

[jrj701]

I just installed one on my 11 RZ2 this weekend but I used port shown in red which already had a hose tapped into it for my heat exchanger since I have the closed system. I just added a tee to accommodate the heater hook up. anyone know if it will work, or should I move it to the other port? Seems like it should work since they are both in the water pump housing. Figures the day after I install it I come across this thread.[ATTACH]34176

[shawndoggy]

it will work fine.

[jrj701]

Sweet thanks.

[gasoline_24]

Are you sure you do not have some plumbed in already? Mine has two plumbed into it I believe. I am doing the same upgrade. In the book it shows them in different locations than the two on mine, but I think they are the same. The nice thing on mine is that they are there with the ball valves and everything else.

[bherrm]

it actually looks like you used pulled the winterization plug from the bottom of the j pipe instead of using the plug on the raw water pump (which should be painted over black):

Gotcha! I will change it since it definitely was smaller fitting... Now in order to wire to my Tige touch, it has a spot for the heater, but since there are three wires for levels, do i just do the high speed and tige touch will adjust accordingly?

Thanks again!