2011 22i graphics?

[NICKYPOO]

I like the ones that are on it now. That was one of the best stock graphics Tige ever put on a boat IMO. The new 22i is pretty good looking though.

I would measure mine but, different hull. I say make it as long as possible.

[jake's02-22i]

Nickypoo. You are right about the graphics that are on the boat right now, I really like them but they are getting old and have marks all over them. The boat needs to have all the little scratches taken out and polished up real nice. Then with the new graphics and new steering cable that we are going to be putting in it will be like a new boat.

We ended up making the new graphics 9 ft. long and they are sitting in my truck. Now I am just watching YouTube trying to figure out how to apply the graphics. anyone with experience in that department?

[Ewok]

Mix some distilled water with a drop of dishwashing soap and a little rubbing alcohol in the mix (alcohol helps the water evaporate faster). Use a fine mist spray bottle and wet the hull, then wet the decal and slide it around until you get it where you want it. Take your time, re-wet as you need to. Then use a credit card or a decal squegee and pull the bubbles out from under the decal, go slow and be smooth. When you get it just right and no bubbles, let the paper dry a little before you peel it back. When you peel the paper off, use the squegee on the paper side to make sure you don't pull the decal off with the paper. Do the smallest decal first as practice so you don't mess up the big one, if there is more than one. It's not that hard but it will be tough and ackward with that big of a decal, good luck.

[ajholt7]

Here is a good place to get any supplies you might need (shameless plug for my brothers business).
http://www.hhsignsupply.com/productcart/pc/home.asp

[brianbaumer]

jake i sent u a PM

[jake's02-22i]

Thanks guys. Brian i PM'd you back sorry I wasn't more help.

[Ewok]

Finished pics?

[jake's02-22i]

haha. Not yet. Sorry guys.

[Dezert22iTige]

Any pics yet ? I have the same boat and I am tired of the factory tribal graphics. When you pulled your graphics off what did you use to remove the oxidation of the sticker ? Also did you end up finding a place that sells the chrome TIGE decals cheaper than the $100 each from Tige ? Thanks.

[jake's02-22i]

Boat just came out of the dealership so i should have some time to work on it soon. as far as the chrome TIGE decals, I didnt even look but chances are you won't find them any cheaper because no one else will make them.

[jmoore15]

This is how it sits now and I will post an after picture as soon as I get this done.

Boat just came out of the dealership so i should have some time to work on it soon. as far as the chrome TIGE decals, I didnt even look but chances are you won't find them any cheaper because no one else will make them.

Might check with the wrap guys (like wakegraphics in Austin) since they have to take them off of the Tiges wrap.

[jake's02-22i]

It is sad but I never completed this project. I ended up taking all the graphics off the boat and just left it white. I really like it but you can see the goasting of the old graphics, which I hate.