Off Season Boat Projects?

[Dave K]

The list just gets longer and longer?!@#$

2. finish my stereo, with either the Wet sounds or Kickers,

3. install some Wake design racks I bought from mtnsmith,

4. install dock lights,

5. Get rid of the damn manual pump and install full auto ballasts,

6. More LEDS in the cabin,

7. Build a curved light bar with 5 lights. 3 Forward 2 rear. Planning to take a 2" piece of pipe bent it, weld ends on it and powder coat. Then get it run some primary wire from the second battery and install a couple of relays and Contura switches,

8. Speed control,

9. I'll have to investigate it but I'm thinking it would be neat to pick up some LED lights (no housing light only) and set them right into the bottom of the top bars of the tower shining down into the cabin area. Probably have to just figure out the voltage draw-resistor issue. Should be easy to do...I think.

oh ya I forgot #1...

Get a second job to pay for this stuff !! LOL

[murphini]

Have pylon reinforced/glassed in from bottom
Get ECM flashed to deal with Limp Mode
Get wakesurf rack for top of tower

[laserfish]

Well, with the first grandchild being born the end of this month, I doubt the wife will leave any money after Christmas to do anything. Trying to save for a new set of kicker tower HLCD speakers and amp before next season starts. I will feel good if that gets done. Had the interior done this summer, if anyone in the D/FW area needs the name of a good shop let me know. This guy was incredibly reasonable (cheap) and did a great, perfect job. So, the projects are halfway done, if I get the last of the stereo done, I will feel great about it. Hopefully, the reweld on the Metcraft tower will hold one more season.

[Booms]

In no order and if my buddy has space in his heated garage I will.....

1 - Buy a new battery (stereo does not work when engine is not turned on) and wire into some kind of system that will make it so I only have two connections to each battery. Add a battery maintainer.
2 - Thinking of smoothing out/filling the bottom of the 2010 swim deck for surfing. Any ideas how to do that? I was thinking I could pour some kind of self leveling epoxy in the corners where it drags in the water.
3 - Fix stereo issues. Tower speakers are not working unless gain is all the way up on amps.
4 - Sit in it once a month and drink a beer.
5 - Maybe buy a new surf board
6 - Hope Santa is nice to me so I can do all this

[ajholt7]

Replacing hard "e" swim platform pad with SeaDek or a Tige squishy pad.

SeaDek makes the Tige squishy pad.

[petrey10]

1) Gotta get the steering cable put in

2) Clean up the interior

3) New swim platform built for surfin

4) If we got the money Perfect Pass GPS type

5) Shine up the chrome on the trailer

6) repack the bearings

7) Add new sub and retune system

8) New Head Unit with wired remote on drivers side so I CAN CONTROL THE SHOW

[Duncan]

SeaDek makes the Tige squishy pad.

Yeah, the questions comes down to how much extra the Tige pad is over the standard SeaDek. I like the Tige logo on it, but do not know how much of a premium in cost it incurs.

[ajholt7]

Yeah, the questions comes down to how much extra the Tige pad is over the standard SeaDek. I like the Tige logo on it, but do not know how much of a premium in cost it incurs.

You can buy it from SeaDek with that logo, I think. I know when we did the group buy back in the spring Tige approved it.

[Utemachine]

I have an upholstry repair to get fixed and I'm going to replace the rubber on my swim platform.

[jwanck11]

New oil sender
change oil
change impeller
maybe batteries
maybe new trailer tires and wheels

[skyski_tige]

No upgrade plans... Just riding over the winter!

[lancehon]

trailer bunks,recover back seat,refinish teak,figure out better ballist for surfing, lots of cleaning

[ragboy]

Anyone with a Tige touch and love to wakesurf? Have I gotta EASY and amazing project for you. But I am not ready yet. Will show the video soon.

D'oh! Sorry, but it is so cool.

[Duncan]

Anyone with a Tige touch and love to wakesurf? Have I gotta EASY and amazing project for you. But I am not ready yet. Will show the video soon.

D'oh! Sorry, but it is so cool.

Hah! What a tease.

[fog_ducker]

Awaiting video ragboy...............