Tige Surf Gates

[cucv]

duffymahoney ahhh your running listed. I once made that comment to about the 40/60 rule of thumb when running listed. Now I run evenly weighted with tabs and gates. 22v with 3200 lbs Ballast with a 30/70 ratio and add 600 more in the bow isle for a 40/60 ratio on flat water days.

Sent from my SM-S911U using Tapatalk

[duffymahoney]

I seem to like a tall, shorter meaty wave. I call my method hybrid listed. But I don't have tabs as well. Do you have wave videos?

That was all with the suck gate, I hope having control on the gates helps my wave.

[duffymahoney]

I am kind of thinking of pulling my bow bags and running lead in their place, wake makers is saying those bags fill a max of 150-200lbs. Which isn't a lot.

I would take that plumbing and split my L shaped bags into two sections, a finger and a tall big section. That way for big crew days I can not fill the finger, or not fill the big tall section to help the boat out and keep my motor from exploding! Basically give me more ability to fine tune it to crew sizes

[Grebva3]

I have a 2012 RZ4 and use a nauticurl and love the wave. I fill the bow, surf side to max and non surf side 50-75%. I’ve been hesitant with the GSA from reading your input. Do you think your style tabs would work with my boat?

[duffymahoney]

I’m sure the gsa would still be awesome! I wouldn’t shy away from that tech.

[laserfish]

Duffy, excellent work as usual. Can you divulge your gate dimensions, what actuator you used and where you purchased your switch panel? Having the older model with the spray pockets is going to be my challenge. Any ideas for that?

[duffymahoney]

Duffy, excellent work as usual. Can you divulge your gate dimensions, what actuator you used and where you purchased your switch panel? Having the older model with the spray pockets is going to be my challenge. Any ideas for that?

If I was you, I would incorporate them into your spray pocket, like malibu does now. I can share my cut file, but I doubt it would help your hull.