Have been having intermittent issue with tabs not deploying in surf mode. Has now become all the time. I have gone into dealer mode to make sure tabs actually work and they do. I have now resorted to just going into the manual demo mode and activating them there when I surf. Any thoughts on why they are not deploying?
-
-
Is the is the speedo working? Is the GPS puck covered up?
-
I had a similar problem with my port side tabs having intermittent problems deploying… check the relays and make sure the post of where the actuator line is screwed on to is tighten.
Hope this helps
Sent from my iPhone using TapatalkComment
-
Lee, Speedo is working. Only appears to be affecting surf left (starboard tab). If I cycle the “switch” surf side a couple of times it will deploy.Comment
-
Ipm983, I’ll check connections. Where are relays located?Comment
-
It sounds exactly the same problem I had… DM sentOriginally posted by boonecragun View Post
Sent from my iPhone using TapatalkComment
-
Had same issue with the starboard taps plate intermittently working. Ended up being the relay was bad but before that it had actually over extended the taps plate and bent it at the bracket! Thankfully both replaced under warranty and now it works perfect.Comment
-
Can you post publicly instead of DM’s so others can figure this out too?Originally posted by ipm983 View Post
surf tabs just suddenly stopped deploying. Speedo works. I’m thinking relays but I don’t know where they are. Mine's a 2019 ZX25.Comment
-
Well… for my situation… it was the relays… I think the 2019 actuators is different from my 2022…Originally posted by Rumbo09 View Post
But mine is located way in the back near the vents. There should be one for each actuator… and It might be as simple as popped fuse you can reset on the relay itself.Comment
Comment