looking for photos of storage compartments on 2008 22VE tige'

[stang32]

the P.O took the panels out of this boat and i can not for the life of me figure out how they go back in. anyone who has this same boat and can snap a few photos, i would greatly appreciate it

[ern]

which panels are you interested in- engine divider, back panels with removable access panels, or something else? Pics from your end would be helpful.

[chpthril]

Need to know if the boat has factory ballast hard tanks across the transom or NO factory ballast.

[stang32]

hard ballast tanks in the back, im asking about the engine dividers and the small dividers.

[chpthril]

Heres an 07 22ve with OEM ballast and unmolested rear locker, Port side. https://www.mikesliquidaudio.com/ins...t#lg=1&slide=2

[ern]

The engine divider panels on my '08 22VE are not mirror images of each other. They also have to be in "just the right spot" in order to insert the bolts at the top. I do not have ballast tanks in mine. I suggest you start with one panel, place the bottom alongside the Chanels on the floor and try to put the top bolts in. If unable to insert both bolts, turn the panel 180 degrees and try again. If still no fit, try same panel in the other side. Repeat with other engine panel. I don't know what you are calling the small dividers.

[stang32]

i have the engine divider panels figured out, what i am still stuck on are the 2 smaller panels, they are kind of wedge shaped with a cut out on either of them for a large hose to pass through.

[BCRider]

^ those go beside the larger engine divider panels around the fuel lines up against the back of the seat area in the engine compartment. In my 09 there is the large channel for the big engine dividers then there is two small channels running parrallel for these smaller wedge pieces.

[BCRider]

like this.

[stang32]

thats what i thought as well but the dam screw holes do not line up with anything.
thanks for the info

[ern]

Those screw into the edge of the
short trapezoid shaped panel at the front of the locker. Mine only has one screw per panel.