TAPS fried

[petrey10]

o great..........

[petrey10]

where did you get a replacement relay?

[Jason B]

Your Tige dealer. Wanna say it's just shy of $200, but don't quote me...

[Surfdad]

@ Jason B - I walk up to the parts counter and ask for a replacement relay and calming state - and I have brought my own KY.

Update from me - I thought I had the hydraulic, but when I crawled down their it's a Lenco Electric. So I followed the advice of Whitlock87 - I couldn't undo the pin where the ram attached to the plate, so I just unscrewed the plate and ram connection. The ram spins - not easily, but it can be done by hand. I think the ram has like 2" or so of travel and I'd like to get it at 1/2 way - so I spun it 8,734,122 revolutions or at least close to that many.

I wish I had a better way to judge the ram travel than eyeball'ing it.

[KonaKing]

Well this changes everything. You will have coming out of the black box a Yellow, red ,and orange wire I think. There will also be a black which goes to ground. You will also have your smaller gauge wires coming from your throttle handle switch. I would assume your red larger gauge wire will be your common or power back to your ram or jack. yellow and orange will be for up and down. I could be wrong on the color combo or yours could be different but those 3 will run you Taps. Right under the dash you should see a buss bar that will have 12 VDC on to jump from.

[Surfdad]

I'd love to be able to adjust it electrically - any idea which wire is which? The color coding on the wiring diagram from Lenco doesn't seem to match my wires coming out of the relay.

[KonaKing]

PM Sent