2018 RZX2 PNP question

[robricketts]

I have pnp installed in my 18 rzx2. When I fill the rear ballast to say 60 percent they fill to max and start to overflow.

So they are at 100 percent but my ballast indicates 60 to 65 percent.

I let them fill and overflow until the dash indicated 100. I thought this would set the 100 percent so to speak.

Drained ballast to 0 and then refilled back to 100 percent. They were full again at 60 percent.

I have adapted to the inaccurate rear ballast percentage as I don’t surf at max full rears.

Is this a setting issue anyone know what I’ve got going on?


Sent from my iPhone using Tapatalk

[lee]

You can change the ballast timers.

[Germaine Marine]

Settings, ballast, timers

[robricketts]

I did change the timers. I increased the time when I added the pnp.

I will shorten timer length on fill.

I’m guessing from the replies the timer determines the percentage it indicates full.

Thanks.


Sent from my iPhone using Tapatalk

[jslayde1]

I’m guessing from the replies the timer determines the percentage it indicates full.

Correct. Its just a timer. Use a stopwatch to get your correct times and then adjust the timer in the setting section.

[robricketts]

Thanks


Sent from my iPhone using Tapatalk