Does anyone know if a T1200 will fit vertical under the floor in the area between the vdrive and gas tank? The boat is a 22V and I installed the system a couple of years ago with two 1” through hulls but I put a 90 to the ball valve followed by a PVC manifold to two T800 pumps for a total of 4 fill pumps. I have some off and on priming issues so I am thinking about upgrading to t1200 pumps and adding two more through hulls. I am thinking the simplest thing to do would be just to remove the 90 from the current setup, thread the ball valve straight to the through hull and then the new T1200 straight into the valve but I am worried that will be too tall to fit in that area. Any thoughts?
I did a search and found one similar install where rule 1100’s were used but I am bored at work so just trying to plan out my next project and get some opinions.
Pics of the existing setup are below. You cant really see it in the second pic but the port manifold is connected to the through hull via a short section of 1” hose and I am thinking where that dips down a little is what causes most of my priming issues.
Ballast manifold 1.jpgBallast manifold 2.jpg
I did a search and found one similar install where rule 1100’s were used but I am bored at work so just trying to plan out my next project and get some opinions.
Pics of the existing setup are below. You cant really see it in the second pic but the port manifold is connected to the through hull via a short section of 1” hose and I am thinking where that dips down a little is what causes most of my priming issues.
Ballast manifold 1.jpgBallast manifold 2.jpg
Comment