Water draining out when full and cannot stop

[pzbilly]

My 2010 tige RZ 4 keep water draining from 2 front ballasts when full. It cannot stop even I set the time in the setup from tige touch. Pks advise

[chpthril]

search "passive draining", there's quite a few threads. Has nothing to do with the time or gauge in the TT.

[Ewok]

Searching for passive draining will give you lots of results but can you be more specific. What ballast tanks or bags are leaking? Did you add any aftermarket bags? What configuration is it draining? Only 1 side for surfing or all full for wakeboarding? Which thruhulls is the water actually draining from?

[NHarp1]

http://www.tigeowners.com/forum/show...hlight=Passive

[chpthril]

Is anyone know for a 2010 RZ4 equipped with pro wake factory ballast, water in front ballasts keep leaking water after the ballasts are full. Is the pump automatic stop when the ballasts are full?
Is that the sensor problem? How can I stop the pump when the ballast is full and prevent water keep leaking out. Tige touch set yp time in ballast seem not help

These pumps are not controlled by timers or sensors. They will need to be turned off manually by driver.

The unwanted leaking (passive draining) from the front ballast is not a sensor problem, its a plumbing problem.

Where is the water leaking out at? When the ballast is full, it overflows from a vent hose. At that point, turn the pump off.

[Ewok]

Chpthrill, if I'm not mistaken the 2010 RZ4 would have TigeTouch and run off timers for ballast. I'm just curious about the conditions since the OP says it's the front ballast.

[chpthril]

Theres a timer that controls the population of the digital gauge, but not the actual on/off function of the pump, right? Once the pump is on, it stays on until the operator turns if off.

[Ewok]

I've only demoed 2 boats with tige touch but I believe the timer turns the pumps off as well. That's why bigger bags need timer adjustments so the pump doesn't turn off too early.

[mdamon]

I have the tige touch and my pumps do not go off when the timers are done, my dealer says they should, but they have not fixed them. Maybe an update would solve it, but I just turn them off when I hear water coming out of the side.

[pzbilly]

Thanks for the advice. there may be problem on the software as there is no stop function from the touch and 2 ballasts on front change to one in the screen suddenly. I believe I need to update the software and see if the stop button from ballast appears again and then I can stop the pump when water leaking out. Anyway, thanks those inputs from you