2007 22Ve Ballast Install

[thtrog]

Looking Good!

[skippabcool]

how thick was your hull

bottom 3/8"

one side was 3/8" and the other was 1/2" to 5/8"

[Timmy!]

Nice job! Looks like you are just about ready for water testing!

[anewseven]

Looks good!
Now we need to go try it out.

[skippabcool]

Looks good!
Now we need to go try it out.

I guess you need to come out here in about a month.

[glassmaker]

Coming along great....

[anewseven]

With all that beef in the freezer you would think we all would get an invite for some ribs and wake boarding / surfing!

[gwhite94]

That's looking good Skippa...

[skippabcool]

Started the hoses, but not going to get far tonight, other commitments.

You can over heat the hose. It didn't pop until after I had it on the fitting.

[chpthril]

Be sure to lube, it makes insertion easier.

[skippabcool]

Be sure to lube, it makes insertion easier.

Oops I figured that if it was pliable I could just shove it in. Thanks.

[chpthril]

Oops I figured that if it was pliable I could just shove it in. Thanks.

There tend to be a lot of friction between the rubber and barbed fittings when dry. Also, you'll know when its too hot, the hose will start to blister and gets limp.

[Timmy!]

Use dish soap and the tube will slide on easier.

[mls6722]

Looks great so far Skippa. Thanks for the post.

[rmason256]

Be sure to lube, it makes insertion easier.

HA

JK but seriously lube it!