I have an 06 22ve, and I need to remove the rear ballast tanks. Is there something I don't know, I can not pull them out of the two doors on either side of the motor. Surely they were not put in before the motor. Any suggestions?
-
-
You will need to remove the rear bulk-head walls to open up the complete transom. This requires the removal of the batteries and TAPS motor. It is doable though.Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More -
I want to remove the rear ballast tanks to help change the steering cable, check the water pump impeller, change the oil and filter, and the fuel filter. I just bought the boat, it has 142 hours, its a clean boat, kept on Lake travis (fresh water). I just want to make sure that boat has been looked over. I am also going to change the v drive fluid, trans fluid, and belts. Is there anything else that should be checked?Comment
-
I dont think you will need to pull the tanks to change either the cable or impeller
Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And MoreComment
-
I have an 04 22v. I finally removed the tanks and replaced them bags. They where always getting in the way of everything I wanted to do. Best thing I did. You can accomplish all you want to do but its a pain with those hard tanks in. Much nicer with them. I was able to get mine out with out removing anything else, a little tricky though.Comment
Comment