How to wire circuit breakers?

[bamaboy2006]

Hello,

I am about to start on my ballast install and I was wondering what would be the best way to wire my new switches and what kind of circuit breakers do I need.

I will be using three of the mastercraft/Supra ballast switches with the fill/empty lables

Thanks

[chpthril]

At most, you will have a max of 3 pump running. So lets take the load of the T1200 pump, which I think is like 6A each. So you max load would only be 18A's. I would use a 20A breaker to feed all 3 switches, then daisy-chain from one switch to the next with the 12V supply. 12ga wire should be fine.

[bamaboy2006]

At most, you will have a max of 3 pump running. So lets take the load of the T1200 pump, which I think is like 6A each. So you max load would only be 18A's. I would use a 20A breaker to feed all 3 switches, then daisy-chain from one switch to the next with the 12V supply. 12ga wire should be fine.

Thanks