Need some help troubleshooting a ballast pump issue. Have an '06 22Ve that came with 3 Johnson Taluluah reversible pumps (dated 2012, part no 10-24690-03). First trip out this season I noticed the bow pump wasn't running. Doesn't make any sound forward or reverse. I'm far from a boat electrical expert, but all three appear to be run off the main bus under the cockpit. In fact, they're somehow tied to the "tower" rocker switch, as that has to be on to run them. Underneath there seems to be a breaker panel which all looks fine and I don't see any fuses anywhere.
The other two pumps are working fine, it's just the bow pump. I've looked through the site quite a bit and not found anything super helpful, so hoping someone might have some insight.
What I did pick up reading is that these can/should be mounted any way other than pump over motor - which 2 out of 3 of mine are this way, including the "dead" one.
So, is there any way I can verify this thing is dead? Can I put a multimeter on it somewhere? Is there anything else anyone can think of to "troubleshoot"?
Impeller looks good and I tried "forcing some water through (with the switch on) to see if I couldn't "jump start" it sort of. Seems like it's shot, but I'd like to be sure before shelling out for a new one.
TIA
Blake
The other two pumps are working fine, it's just the bow pump. I've looked through the site quite a bit and not found anything super helpful, so hoping someone might have some insight.
What I did pick up reading is that these can/should be mounted any way other than pump over motor - which 2 out of 3 of mine are this way, including the "dead" one.
So, is there any way I can verify this thing is dead? Can I put a multimeter on it somewhere? Is there anything else anyone can think of to "troubleshoot"?
Impeller looks good and I tried "forcing some water through (with the switch on) to see if I couldn't "jump start" it sort of. Seems like it's shot, but I'd like to be sure before shelling out for a new one.
TIA
Blake
Comment