Bilge Pump housing broke recommend new one

[gil5784]

Hey guys went out to Mead today and notice auto bilge was turning on but no water being pumped out. After further inspection notice the housing connected to the hose was cracked and just pumping the water back into the bilge. So my question is do you have any recommendations on replacement. Any suggestions are appreciated.
uploadfromtaptalk1435982344948.jpg


Sent from my Nexus 6 using Tapatalk

[robert theisen]

You can go to Walmart and find a 500 gph pump to replace yours. Try and use as many mounting screws as line up from the original pump. Stick a drill bit in the existing holes and mark the depth with electrical tape. Use that as a guide for depth to drill remaining holes. You want to use a drill bit a couple of 32nds smaller than the mounting screws. The wiring is color coded. Good luck.

[gil5784]

Thanks for the info, this will be my Friday project

Sent from my Nexus 6 using Tapatalk